OVERVIEW

 
'U' Series
'T' Series
'C' Series
'K' Series
'R' Series
Polylined KGV
Hy-Seal 'E' Series
Hy-Seal 'M' Series
Concentric Check Valve
Hy-Stroke Linear Actuators
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

CONTACT US

 
14/78 Reserve Road
Artarmon, NSW  2064
PO Box 116
Artarmon. NSW - 1570
AUSTRALIA
Tel: +61 2 9437 3288
Fax: +61 2 9437 3211
email: hpvalves@hpvpl.com
 
 
 
   

'C' Series

 
The 'C' Series Valve offers a cost-effective solution to slurry control applications. Collapsing the sleeve with gas or fluid pressure induced between the sleeve and the outer valve body operates the valve. The valve body acts as a built in actuator, eliminating the need to fit costly conventional actuators.

Varying the pressure within the annular space between the body and the sleeve can open, throttle or close the valve as required. This is an extremely simple valve with only one working part (the sleeve), which has been specially developed for the purpose. This extends in-Iine service and lowers maintenance costs.

By filling the body chamber of the valve with glycerine or a similar fluid the valve may be converted to act as a pressure gauge.

The valve closes like the shutter of a camera and leaves a pinhole at the centre of closure, therefore these valves are not drop-tight on clear fluids or gases. Any suspended solids in the pipeline medium assists closure by blocking the pinhole. Therefore all sizes will act as stop valves for such services as slurries, ash, dust, cement, powders and dirty water, etc. The sleeves are available in a wide range of elastomers and trims to meet exact service and flow specifications.

The C Series Valve is sometimes referred to as the Squeeze Valve or Muscle Valve.
 

   
 
FEATURED PRODUCTS
 

'T' Series
 

'K' Series
 

Polylined KGV
 

'U' Series
 
2009 HY-PERFORMANCE VALVES PTY LTD  All Rights Reserved  Standard Terms and Conditions